Application Instructions

Adhesive Vinyl Decals:

-Clean application surface with rubbing alcohol.
-Slowly peel back transparent transfer tape with decal attached,
making sure all of the vinyl pieces stick to the tape.
If the decal has trouble sticking to the transfer tape,
rub firmly with a credit card to re-adhere it.
-Place decal where desired.
-Rub credit card over decal to fully adhere.
-Peel off transfer tape at 180 degree angle.

-Decal is made to be applied to a smooth, non-porous
surface, such as metal, glass, plastic, or sealed wood.
Application to a painted surface may cause damage
to paint when removed.
-If applying to drinkware, handwash only.
 

Mixer Decals:

-Clean mixer thoroughly with soap and water. Let dry.
-Clean application area with rubbing alcohol
or Windex to remove all oils.
-Cut decals apart as needed.
-Peel decal from backing.
-Place where desired and rub firmly with finger.
-Remove transfer tape at 180 degree angle.
-Decals can be cut to fit around corners and curves, or cut in half to fit smaller areas.

Iron On Decals:

Prep: Wash garment withOUT fabric softener and dry.
Peel wax paper backing away from decal,
leaving the decal attached to the adhesive layer.
Place decal against garment where desired.
Set heat press to 295 or iron between cotton and linen.
Cover design with Kraft paper or non-stick cover sheet.
Place on at, hard surface (ironing board not recommended).
Press iron with rm pressure (do not slide iron).
Press each section of design for 10-15 seconds.
If areas of design lift after application, replace cover sheet
and re-press for 5-10 seconds.
Peel adhesive layer away while still warm.
 Care Instructions:
• Wait 24 hours before 1st wash
• Machine wash cold / mild detergent
• Dry on normal dryer setting
• Do not dry clean or bleach
Applies To:
• 100% cotton
• Poly/cotton blends
• 100% polyester
• Leather
• Lycra®/spandex